Sometimes you just have to make your own jewelry tools

by lianabennett on March 5, 2010

in Uncategorized

I have a new bracelet design that requires an oval shaped bracelet mandrel for final heat treating. I bought a cast steel mandrel years ago (very expensive) but the steps are just not long enough for my current needs. The steps are 1 3/4″ long and I need one 2 1/4″ in length. I scoured the Internet for an oval bracelet mandrel, but the only ones I could find were tapered (won’t work) or stepped, just like mine. Hummm…. what to do.

I was thinking, if I had access to a lathe, I could make one out of oak or steel. We have an ancient metal lathe down in the shop, but, it hasn’t been used for years and I doubt it still runs. Still, I could spend a week moving the junk piled up in front of, and on top of it, cleaning the lathe and checking to see if it still runs.

Then, the perfect solution came to me. As usual, my ideas always seem to come in the early hours of the morning. I needed to find a plastic bottle, the right diameter. My oval design is 2.48″ wide x 2.29″for an average diameter of 2.39″. I buy plastic squeeze bottles from Wal-Mart for dispensing my assorted resins, and these turned out to be the perfect diameter. I ran a quick test for heat resistance. Yep, the plastic squeeze bottle can handle the 180 deg heat treatment temperature with no melting or distortion. I cut off the top of one of the bottles, squeezed it into the right shape with an existing metal cuff bracelet, filled the bottle with plaster of paris, and let it cure overnight.

Voila! Here it is! And, I spent maybe 2 dollars making it. My mandrel turned out a whopping 5 inches tall. That means, I can heat treat 2 bracelets at a time.
Home made bracelet mandrel

lianabennett

lianabennett

lianabennett

Latest posts by lianabennett (see all)

{ 2 comments… read them below or add one }

larryseiger March 9, 2010

Hi Liana,
can you show us a picture of the type of bracelet you make with this tool? I think it’d add a lot to the article.
Larry

lianabennett March 9, 2010

Hi Larry,
It’s a spring loaded, clapper style bracelet made of urethane resin that requires 6 hours of post-curing at 180 degrees. I will show this new design in my next post.

Previous post:

Next post:

WordPress Admin