Bands are really easy with the JWX-30 mill. the models are milled on the rotary fixture as shown here. The wax is attached by sliding it on to the shaft of the fixture, and stays in place by means of friction. The screw fixture to the left of the shaft is used to remove the wax after milling, by rotating towards the wax and pushing it off without stressing the wax.
Many rings can be milled at once on this fixture. I milled both of these bands at the same time in a few hours. The inside of the bands will have to be hand finished to the proper finger size, but that is all the additional work needed before casting.
{ 1 comment… read it below or add one }
I found your site on del.icio.us this morning and really liked it. I bookmarked your blog and will definitely be back soon to read your new posts!