My Daughter Anika uses Jewelry Cad Dream

by Allan Straton on May 15, 2014

30

Hi

I am Allan Stratton.

My Daughter is generation Y.

She was lucky to have been taught Jewelry Cad Dream and now knows it very well.

After the first week she knew how to make a ring.

She then designed her sisters engagement ring.

This ring is now featured on the front page of Jewelry Cad Dreams web site.

Anika had never been trained as a  jewellery.

I have to admit that the jewellery that can be created on Jewelry Cad Dream would be hard to impossible to recreate by hand.

She could create jewellery far better than I could in my 45 years at the bench.

That is the power of this program.

The other important point is that she can change any part of the file at will.

Anika can also make the settings, shanks or any other part of the file and make a ring in minutes not hours or days.

The file she creates is worth more than the ring.

She can create one ring and alter it to make 10, 20 or more patterns.

She can alter the size, width and depth or any other part of the ring or file.

She can then save it to use another day.

To see Anika’s ring go to www.jewelrycaddream.com

So what I am saying is that anyone can lean to design not basic jewellery but jewellery as good as jewellery tradesmen.

You still have to finish the cast items but if you don’t want to finish the item you can always sell the file over an over again because the designer owns the rights to the file.

No other Cad program can offer this.

And the people who buy the file can alter the file as well.

You can rent the program for 1 month for US$275.00 and give it a go.

Small cost if the program is going to save you time and money.

Tell them Allan sent you when you rent the program.

My web site is

www.thehouseofstratton.co.nz

Allan

 

 

Comments on this entry are closed.

Previous post:

Next post:

WordPress Admin